Re: [DIYbio] Sensomatic - a possible low cost microbiology sensor/controller board

On 03/29/2013 06:28 AM, John Griessen wrote:
> On 03/29/2013 01:00 AM, Jonathan Cline wrote:
>> Comments are welcome especially regarding similar controllers already out there for comparison to this possible project.
>
> Cheapstat exists. It's a potentiostat board. Probably over $100 once you add sensors, and mostly
> intended for electrode voltage studies. Programmed in Java.

Really it is only the PC side code that is Java. Not sure what the AVR firmware is done with.

Your UBW and YAML driven method seems better.

A version of this with the firmware only about taking a quick accurate analog reading,
and leaving the cycling timings in YAML might be an improvement.

--
-- You received this message because you are subscribed to the Google Groups DIYbio group. To post to this group, send email to diybio@googlegroups.com. To unsubscribe from this group, send email to diybio+unsubscribe@googlegroups.com. For more options, visit this group at https://groups.google.com/d/forum/diybio?hl=en
Learn more at www.diybio.org
---
You received this message because you are subscribed to the Google Groups "DIYbio" group.
To unsubscribe from this group and stop receiving emails from it, send an email to diybio+unsubscribe@googlegroups.com.
To post to this group, send email to diybio@googlegroups.com.
Visit this group at http://groups.google.com/group/diybio?hl=en.
For more options, visit https://groups.google.com/groups/opt_out.