Re: [DIYbio] Electronic requirements for redesign of Arduino PCR thermal cycler

On Fri, Feb 27, 2015 at 12:20 AM, Nathan McCorkle <nmz787@gmail.com> wrote:
> This would be a fun project to build a schematic and
> printed-circuit-board for. I will have time in a few weeks I think.
> But essentially it's an arduino on the left-side of the schematic
> page:
> http://2013.igem.org/wiki/images/b/b5/Pspcr_schema.png
>
> and the peltier control stuff is on the right-side.
>
>
> You could probably also just use a couple easydrivers:
> http://www.ebay.com/itm/EasyDriver-Shield-stepping-Stepper-Motor-Driver-V44-A3967-For-Arduino-/400522271040

Whoops I meant this part:
http://www.ebay.com/itm/Stepper-Motor-Drive-Controller-Board-Module-L298N-Dual-H-Bridge-DC-For-Arduino-/170926726867?pt=LH_DefaultDomain_0&hash=item27cc06ded3

--
-- You received this message because you are subscribed to the Google Groups DIYbio group. To post to this group, send email to diybio@googlegroups.com. To unsubscribe from this group, send email to diybio+unsubscribe@googlegroups.com. For more options, visit this group at https://groups.google.com/d/forum/diybio?hl=en
Learn more at www.diybio.org
---
You received this message because you are subscribed to the Google Groups "DIYbio" group.
To unsubscribe from this group and stop receiving emails from it, send an email to diybio+unsubscribe@googlegroups.com.
To post to this group, send email to diybio@googlegroups.com.
Visit this group at http://groups.google.com/group/diybio.
To view this discussion on the web visit https://groups.google.com/d/msgid/diybio/CA%2B82U9KmO9yuH177rEies37GkFY1Hhs8zBOUtiFd5PtmnHohfQ%40mail.gmail.com.
For more options, visit https://groups.google.com/d/optout.