So I have the Parallax Propeller running the CCD with no timing jitter
whatsoever, on 60 lines of Assembly code. The Propeller has a pretty
powerful set of Assembly instructions, though each takes about 4 clock
cycles to complete, so even though its running at 96Mhz, it's not as
fast as it sounds, though with some timer trickery you can make signal
changes on the GPIO pins at 96Mhz.
Last night I finished soldering a breakout board for the ADC, which I
made using copper clad PCB sprayed with black spray paint and cut on a
laser cutter, then etched with HCL and H2O2. In the next week or so I
should have digitized pixels coming over to the Propeller, and then
I'll start getting them sent out via USB.
Check out the breakout board here:
http://www.youtube.com/watch?v=nidjp-jl7Fk
Last project update was: On Sat, Jan 7, 2012 at 7:47 AM, Nathan
McCorkle <nmz787@gmail.com>
--
Nathan McCorkle
Rochester Institute of Technology
College of Science, Biotechnology/Bioinformatics
--
You received this message because you are subscribed to the Google Groups "DIYbio" group.
To post to this group, send email to diybio@googlegroups.com.
To unsubscribe from this group, send email to diybio+unsubscribe@googlegroups.com.
For more options, visit this group at http://groups.google.com/group/diybio?hl=en.
0 comments:
Post a Comment