Pieter ,
Your Centrifuge seems like a nice one , I think u should make a small metal couple to connect your 3D printer part with the motor rather than connecting it directly
On Thursday, February 12, 2015 at 3:07:19 AM UTC+5:30, Pieter wrote:
-- Your Centrifuge seems like a nice one , I think u should make a small metal couple to connect your 3D printer part with the motor rather than connecting it directly
On Thursday, February 12, 2015 at 3:07:19 AM UTC+5:30, Pieter wrote:
Perhaps a design I made some time ago can help you get going: https://github.com/PieterVanBoheemen/RWXBioFuge
However, even with small 8 place or 20 place rotors that I 3D printed, I could hear the filament getting loose and flying against the sides. So I would certainly not go for even bigger 3D printed rotors
-- You received this message because you are subscribed to the Google Groups DIYbio group. To post to this group, send email to diybio@googlegroups.com. To unsubscribe from this group, send email to diybio+unsubscribe@googlegroups.com. For more options, visit this group at https://groups.google.com/d/forum/diybio?hl=en
Learn more at www.diybio.org
---
You received this message because you are subscribed to the Google Groups "DIYbio" group.
To unsubscribe from this group and stop receiving emails from it, send an email to diybio+unsubscribe@googlegroups.com.
To post to this group, send email to diybio@googlegroups.com.
Visit this group at http://groups.google.com/group/diybio.
To view this discussion on the web visit https://groups.google.com/d/msgid/diybio/e7be18e1-0156-41b7-ad50-2e432fec73af%40googlegroups.com.
For more options, visit https://groups.google.com/d/optout.
0 comments:
Post a Comment