Re: [DIYbio] Re: Bento Lab Feedback and uBiome kit up for grabs.

Probably to minimise thermal mass in the heat block, to improve efficiency and ramp rate.

On 4 April 2016 15:18:03 IST, Alexey Zaytsev <alexey....@gmail.com> wrote:

Hi, Bethan,

congratulations on successful kickstarter!

I'm also developing an open-source PCR, and was wondering if you could answer a couple questions if it's not a secret.

I see those small holes between the tubes in the thermocycler. I've seen similar design in a new bio-rad cycler. What's the reason to have them?

Also, what are your ramp up/down temperatures?

Thanks in advance!

On Sun, Apr 3, 2016 at 12:59 AM, Bethan <bwol...@gmail.com> wrote:

Hey Jake - max RCF is 19200. Outer radius 43mm and max RPM 20000. 


On Saturday, April 2, 2016 at 3:55:10 AM UTC+1, Jake wrote:

Is it a misprint or does that little centrifuge really pull 20k RCF?

--
-- You received this message because you are subscribed to the Google Groups DIYbio group. To post to this group, send email to diy...@googlegroups.com. To unsubscribe from this group, send email to diybio+un...@googlegroups.com. For more options, visit this group at https://groups.google.com/d/forum/diybio?hl=en
Learn more at www.diybio.org
---
You received this message because you are subscribed to the Google Groups "DIYbio" group.
To unsubscribe from this group and stop receiving emails from it, send an email to diybio+un...@googlegroups.com.
To post to this group, send email to diy...@googlegroups.com.
Visit this group at https://groups.google.com/group/diybio.
To view this discussion on the web visit https://groups.google.com/d/msgid/diybio/4fc7edfb-87b6-4f08-8190-4187cd1b6fd9%40googlegroups.com.

For more options, visit https://groups.google.com/d/optout.

--
Sent from my Android device with K-9 Mail. Please excuse my brevity.