It doesn't actually go down into a joint, but that is a good idea. The electrode has to go over one edge so it can make contact with the electrodes in the box. these are recessed into the bottom slot of the box.
--AOn Sat, Nov 2, 2013 at 11:02 PM, John Griessen <john@industromatic.com> wrote:
On 11/02/2013 12:47 AM, Avery louie wrote:Why does the electrode wire go over the edge on one side, and down to a joint in the plastic box on the other?
The gel casting trays I have are cheap- $20 each. This means you can buy a few and pre-cast gels, in parallel which saves you
time. They are also reusable.
I'm referring to this photo:
http://tequals0.files.wordpress.com/2013/10/img_1991.jpg
JohnTo view this discussion on the web visit https://groups.google.com/d/msgid/diybio/5275BCD7.5060505%40industromatic.com.
--
-- You received this message because you are subscribed to the Google Groups DIYbio group. To post to this group, send email to diybio@googlegroups.com. To unsubscribe from this group, send email to diybio+unsubscribe@googlegroups.com. For more options, visit this group at https://groups.google.com/d/forum/diybio?hl=en
Learn more at www.diybio.org
--- You received this message because you are subscribed to the Google Groups "DIYbio" group.
To unsubscribe from this group and stop receiving emails from it, send an email to diybio+unsubscribe@googlegroups.com.
To post to this group, send email to diybio@googlegroups.com.
Visit this group at http://groups.google.com/group/diybio.
-- You received this message because you are subscribed to the Google Groups DIYbio group. To post to this group, send email to diybio@googlegroups.com. To unsubscribe from this group, send email to diybio+unsubscribe@googlegroups.com. For more options, visit this group at https://groups.google.com/d/forum/diybio?hl=en
Learn more at www.diybio.org
---
You received this message because you are subscribed to the Google Groups "DIYbio" group.
To unsubscribe from this group and stop receiving emails from it, send an email to diybio+unsubscribe@googlegroups.com.
To post to this group, send email to diybio@googlegroups.com.
Visit this group at http://groups.google.com/group/diybio.
To view this discussion on the web visit https://groups.google.com/d/msgid/diybio/CAL4KOmiYMDqZSZswSWOEXc6ka0j_vhOBnvC6Q8MN2xhjtQ9zCA%40mail.gmail.com.
For more options, visit https://groups.google.com/groups/opt_out.
0 comments:
Post a Comment