Re: evaporation losses... was: [DIYbio] Electronic requirements for redesign of Arduino PCR thermal cycler

On 02/28/2015 03:57 AM, Nathan McCorkle wrote:
> perhaps hone the
>>calculation to get rid of my 'mollier diagram; guesstimation issues?

I did not see temperature in the model, so it seems odd to miss that...

or is it there as a worst case constant somewhere at about 40 deg C?

As evaporation happens from a capillary, the exposed water surface will shrink back into
the capillary and cause evap slow down more because it is in a well where there will be no breeze.

That part seems to become a diffusion calculation that will vary as depth of the "well".

--
-- You received this message because you are subscribed to the Google Groups DIYbio group. To post to this group, send email to diybio@googlegroups.com. To unsubscribe from this group, send email to diybio+unsubscribe@googlegroups.com. For more options, visit this group at https://groups.google.com/d/forum/diybio?hl=en
Learn more at www.diybio.org
---
You received this message because you are subscribed to the Google Groups "DIYbio" group.
To unsubscribe from this group and stop receiving emails from it, send an email to diybio+unsubscribe@googlegroups.com.
To post to this group, send email to diybio@googlegroups.com.
Visit this group at http://groups.google.com/group/diybio.
To view this discussion on the web visit https://groups.google.com/d/msgid/diybio/54F1DD42.5080405%40industromatic.com.
For more options, visit https://groups.google.com/d/optout.

  • Digg
  • Del.icio.us
  • StumbleUpon
  • Reddit
  • RSS

0 comments:

Post a Comment